Extrusion Operator - SDT2 - Plant 8T - C Shift

Position Overview
To operate the Spin Draw Texturing (SDT) machines, which includes doffing, labeling, and inspecting yarn along with cleaning and restringing points as they break. Disposition of off-quality yarn and housekeeping are required as well.
Keep winders doffed, ensuring proper identification of the yarn and following packing and inspecting procedures.
Doff 40 to 50 packages per hour from a cradle located 19 inches above the floor.
Secure doff labels from overhead label containers and reach to cut yarn into air gun from the top aspirator.
Must push pin trucks full of yarn and boxes of yarn on wheels, over mostly smooth concrete floors.
Disposition of break packages and off-quality yarn.
Clean points and restring as necessary.
Patrol points, checking thread paths and checking for crossover or undrawn filaments.
Keep work area clean and free of fly waste
Weigh packages and record weight/doff number per schedule.
Prepare corrugated cardboard as needed.
Remove full waste boxes and replace with empty boxes with correct number of layer pads.
Miscellaneous assignments from shift or day supervisor.
Provide relief in Extrusion spinning area.
Provide relief in Extrusion SDT1 area.
Provide relief as Extrusion Technician II (SPO or Control Room).

Don't Be Fooled

The fraudster will send a check to the victim who has accepted a job. The check can be for multiple reasons such as signing bonus, supplies, etc. The victim will be instructed to deposit the check and use the money for any of these reasons and then instructed to send the remaining funds to the fraudster. The check will bounce and the victim is left responsible.

More Jobs

Grader-Saw - Rough Mill - Plant H5 - 2nd Shift
Clinton, SC Shaw Industries Inc
LTO - Rough Mill - Plant H5 - 2nd Shift
Clinton, SC Shaw Industries, Inc.
Operator C- Heat Treat Stacker (1st Shift)
Fort Mill, SC LUK Inc
Press Setup Operator C- 2nd Shift
Fort Mill, SC LUK Inc
Assembly Setup Operator- 1st Shift
Fort Mill, SC LUK Inc